Anti GPU Sag Adjustable Graphics Card Support Brace Stand with Metal Core and Dual Magnet Base

• This is 3D printed with a metal core and can be used as an anti-sag graphics card support. The material (PETG) can withstand temperatures of up to 230F before any warping occurs.
• The graphics card support piece is adjustable from a minimum height of 56.3mm (2.22") to a maximum height of 82mm or (3.24").
• Unlike other fully 3D printed GPU supports, this piece uses a stainless steel threaded rod that goes into a 3/4" metal threaded insert on the inside of the top piece.
• This metal core allows the GPU support to hold a significant amount of weight (see last picture) and will be more than capable of supporting and preventing sag on any graphics card.
• The base of this piece has two integrated magnets to provide extra stability.
• Installation is simple, using the graphics card support piece, unscrew the bottom piece until the total length roughly lines up with the gap under your graphics card. Place the piece under your graphics card (make sure its not touching any fans) and unscrew the bottom until it is supporting the graphics card and preventing it from sagging. IMPORTANT: Do not overextend the support piece so that your graphics card is angling up at the end. This can damage the PCIe connection on your motherboard. 
• Listing includes: one graphics card support piece and installation instructions.
• Measure before ordering. Ensure that the gap underneath your graphics card is at least 2.22" but also less than 3.1" to ensure that this piece will fit and allow for height adjustments. Not responsible if the piece does not fit your PC as the min/max dimensions have been stated in this listing. No refunds will be given for this reason.

• The listing does NOT include the graphics card (RTX 3080) or the computer/any accessories used in the images