NOTICE: BEWARE of the other seller with very fine easy to break wires! Look at our cable, then look at theirs. Ours is a MUCH stronger cable.
See the difference!
See how many we have sold? Yes, ours is the best cable and almost 200 buyers agree.

These are GENUINE manufactured 10 pin mini-din connector cables (3 feet with stripped and tinned wires as shown).
These are not made by Yaesu but fit PERFECTLY in FTDX10, FT-450, FT-450D, FT-950, FTDX-1200 
See the pics, look at the high quality of this cable and connector!
Create the output you want, ALL 10 wires have been brought out saving you hours of work to solder to those tiny pins on the connector! 
We also make this cable into a complete Yaesu 10 pin amplifier keying or amplifier keying with ALC.
Keying only ---->>> https://www.ebay.com/itm/143982968839 
Keying and ALC ---->>>  https://www.ebay.com/itm/324311418742

According to the Yaesu manual for these radios (see your radio manual).
Shown below for FTDX10, FT-DX1200, FTDX-1200, FTDX1200, FT-450, FT-450D, FT-950 (CONFIRM pins/functions with your radio manual!)
PIN 1 BLACK - + 13.8 VDC out
PIN 2 BROWN - TX GND (amplifier keying, we HIGHLY suggest using our RBI-1 Amplifier Buffer Interface, see https://www.ebay.com/itm/140456018374
PIN 3 RED - GND (ground)
PIN 4 ORANGE - BAND DATA A
PIN 5 YELLOW - BAND DATA B
PIN 6 GREEN - BAND DATA C
PIN 7 BLUE - BAND DATA D
PIN 8 PURPLE - TX INHIBIT 
PIN 9 GRAY - ALC in (connect to your amplifier ALC jack)
PIN 10 WHITE - TX REQ IN

The FTM-100DR and FTM-400DR also use the same 10 pin jack but the FUNCTIONS are as described in the FTM-100DR and FTM-400DR manual. Use your manual to determine functions for any pins.


Want a less expensive Yaesu amplifier keying cable that uses the 8 pin mini-din?
SEE OUR EBAY STORE under "CABLES" category.