1970, 1971, and 1972 Dodge Dart with Factory Disc Brake Lower Ball Joints.

***Vehicles with Aftermarket Disc Brake Conversion Kits will Not Fit. These Lower Ball Joints are the Factory Stock Disc Brake Design with the 3.850" (center to center) Spacing on the Mounting Holes. If your Spacing is 4.375", then you will need the later design. Please contact us and we can swap these for the Factory Design.***

These parts are Factory Design and will only work with Stock Vehicles.

This Kit Contains All Of The Pieces Below:

Inner Tie Rod Ends, Right and Left

Outer Tie Rod Ends, Right and Left

Tie Rod Sleeves (2 Each)

Sway Bar Bolts (2 Each)

Strut Rod Bushings (2 Each)

Upper Ball Joints (2 Each)

Lower Ball Joints (2 Each)

Upper Control Arm Bushings (4 Each)

Lower Control Arm Bushings (2 Each)

Upper Control Arm Bumpers (2 Each)

Lower Control Arm Bumpers (2 Each)

Idler Arm

This Kit Also Contains:

The Cotter Pins, Rubber Grease Seals/boots, Zerk Fittings (When Applicable), And The Bolts For The Ball Joints, Plus The Tie Rod Sleeve Bolts, Nuts, And Clamps.