HL-100R is an LCM module with buttons designed to configure Hides receivers (HV-1x0 series).


Depending on the firmware installed, there are two models; one is HV-100T for transmitter configuration, and the other one HV-100R for receiver configuration.

The control bus interface between HL-100 and transmitter/receiver is UART, and the parameters are 57600,n,8,1.


Dimension (mm)

 

TOP/ Bottom view

 


 


 


 


 


 


 


 


 


 


 


 


 


 


HL-100R Receiver control

  1. Power on

  2. Press “OK” button when Rx is detected and the LCM shows “PRESS THE OK KEY” and “KEYBOARD LOCKED”.

     

  3. Press “RIGHT” or “LEFT” button to switch different settings.

  4. Set frequency

    1.  Press OK to enter configuration mode.

    2.  Press UP or DOWN to change the number for each digit.

    3.  Press OK to leave configuration mode

  5. Set channel bandwidth

    1. Press OK to enter configuration mode.

    2.  Press UP or DOWN to change the bandwidth.

    3.  Press OK to leave configuration mode

  6. Check channel receiving strength and quality.

    You can also check if the signal is “lock” or “unlock”.

    Press  UP/ DOWN button to switch to ANT1 or ANT2.

     

     

  7. Save changes. You need to save all changes to apply new settings.

    1.  Press OK in following screen.

    2.  Press LEFT/RIGHT button to YES and press OK.