Comes with a 2 pin 6.3mm battery connector!

  We have all the different throttles available pictured above, it comes standard with the throttle in main picture, if you want ANY other throttle you must send a note to seller at checkout and then slick 'AD" after you type it or it dont get sent with order..simply include the # in the picture of the throttle you see!

TAKE NOTE--Please take note, this ONLY fits a "brushed motors" and brushed motors only have 2 wires coming out of them, IF your motor has more than 2 wires coming from it (3 wires and 5 smaller) you have a Brushless or BLDC motor so NO this will not run it. This can handle up to 1000 watts only.

1000 Watt (Will work with any wattage up to 1000 watts) -48V 30amp Brushed Motor Controller with matching plug n play digital read throttle with a built in key which will turn your scooters power on and off! 

Don't try and guess what goes where, simply plug in your motor and battery to the controller and your done!

This controller also has a few cool optional outputs for headlights or taillights and brake lights too.. Comes with all opposite end connectors to match controller and all the brass pins too!

This controller is for brushed (Also known as "PM" or "Magnet" motors)-Not for brushless motors 

This is a very nice controller, durable and long lasting...With this digital read out throttle you know exact voltage you have,no more dummy lights which is a MUST with lipo lithium battery packs.

Be sure to check out our store for a wide selection of top quality scooter parts!


6 pin connector for throttle & on/off feature.
2 wire connector red and black-Charger port
2 wire connector black and yellow-Optional Cut off for brake switch for front or rear
2 wire connector black and yellow-Optional Cut off for brake switch for front or rear
3 wire male connector black and red-Optional brake lights (48v)
3 wire male connector red,black -Optional taillights or headlights (48v)
2 wire male connector red and black-Battery wires
2 wire female connector blue and yellow-Motor Wires 

Digital Read Out Info
Maximum voltage indicates fully charged.
Low voltage indicates the battery runs out.
 Fully Charged voltage is about 54V, the lowest of about 49V (charge)

Most controllers in 48v 1000 watt ,as you most likely know, do not have this many options to plug right in and thats why this controller is so user friendly...