

















Device Specifications
Mechanical: S-rod with electronics housing on rod, 3-piece breakdown construction, nonmetallic telescoping lower rod,
• Operation Mode: 3+1
Motion Mode: ALL-METAL,NOTCH,MEMORY
Non-motion Mode: PINPOINT
• Coins Depth Indication: 5 grades
• Sensitivity Control: 5 grades
• Target Metals Discrimination: 4 kinds
0 to 99 double digits
• Signal Strength Indication:5 grades
• Sound Frequency: 3 kinds of frequency indicating different
metals
• Volume Indication: 3 grades
• Battery Indication: 3 grades
• Earphone Jack: 1/8 inch earphone jack
• Power Supply: two 9V alkaline battery
How to Pinpoint
Position the search coil an inch or two (2.5-5cm) above the ground, and to the side of the target. Then press PP."PP" on the LCD
flashes. When the LCD displays steady "PP", you can start to
move the search coil slowly across the target, and the sound will
communicate the target's location. As you sweep from side to side, and hear no sound at the ends of the sweep, the target is located
in the middle of that zone, where the sound is loudest and the
greatest number of segments of depth is displayed. If the sound is
loud over a wide area, the buried object is large.Use Pinpoint to
trace an outline of such large objects. Narrow It Down
To further narrow the field of detection, position the search coil
near the center of the response pattern (but not at the exact
center), then press PP again. Now you will only hear a response
when the search coil is right over the top of the target. Repeat this
procedure to narrow the zone even further. Each time you repeat
the procedure, the field of detection will narrow further. To exit thePP mode, press PP again.
Narrow It Down
To further narrow the field of detection, position the search coil
near the center of the response pattern (but not at the exact
center), then press PP again. Now you will only hear a response
when the search coil is right over the top of the target. Repeat this
procedure to narrow the zone even further. Each time you repeat
the procedure, the field of detection will narrow further. To exit the
PP mode, press PP again.
CAUTION
1) In areas with heavy traffic, please not wear earphone, in case
an accident occurs. 2) Always obtain permission before searching any site. 3) Keep away from the area where may bury the electrical line, cable line or pipeline, in particular, the pipes that are full of
flammable gases and liquids. 4) Do not detect in the military area where may bury bombs or gas
explosives. 5) When digging the target, use the reasonable method, not
destroy the vegetation. Leave the land and vegetation as it was,
fill in the holes after the digging
