(deposit is £250 the cost of replacing the fobfix tool itself)

 HOW IT WORKS I send you the fobfix

The tool plugs into the OBD which has to be live if your interior light isnt working then you need to find the fuse as its the same fuse for the OBD 

you can add upto 4 keys to the vehicle only 

you use the programmer add your keys then when you return the fobfix back to me i then return you £200 so total hire of the fobfix is just £50 if after 7 days the fobfix isnt returned it will be another £50 and so on

 ************If you can try add 1 key before deleting all keys just in case there’s a fault in the vans electrics************* 

The Transit MK7 OBD port can be found under the steering wheel. Simply pull the panel to release the clips and access the port

 

 MODE 1— CHECK NUMBER OF PROGRAMMED KEYS 1. With ANY key, turn your ignition to position II. At this point your dash should be lit.2. Plug the tool in to the vehicles OBD connector with all DIP switches set to OFF.3. The LED on the tool will light up RED/GREEN/BLUE and you will hear 3 as- cending tones to indicate it is powered. 4. After approximately 2 seconds, the LED on the tool will flash ORANGE as it sends the commands. It will then flash GREEN and beep a number of times corresponding to the number of keys currently programmed to the vehicle. The tool will flash/beep 5 times if there are no keys programmed. 5. The tool will then light up again RED/GREEN/BLUE and you will hear 3 de- scending tones to indicate the process has finished.

MODE 2 — ADD KEYS 1. Turn your ignition key to position II WITH THE KEY YOU WISH TO ADD. At this point your dash should be lit. 2. Plug the tool in to the vehicles OBD connector with DIP switch 4 ON. 3. The LED on the tool will light up RED/GREEN/BLUE and you will hear 3 ascending tones to indicate it is powered. 4. You will then hear another high beep and see a BLUE flash. At this point the tool is in ‘add key mode’. 5. The LED on the tool will flash ORANGE as it sends commands to the vehicle. After approximately 5 seconds, the LED on the tool will flash GREEN and beep a number of times corresponding to the number of keys currently programmed to the vehicle. If the procedure has succeeded, this number will be +1 to the number of currently pro- grammed keys. 6. The tool will then light up RED/GREEN/BLUE and you will hear 3 descending tones to indicate the process has finished. 

MODE 3 — DELETE KEYS 1. Turn your ignition key to position II WITH ANY KEY. At this point your dash should be lit. 2. Plug the tool in to the vehicles OBD connector with DIP switch 3 ON. 3. The LED on the tool will light up RED/GREEN/BLUE and you will hear 3 ascending tones to indicate it is powered. 4. You will then hear another two high beeps and see two BLUE flashes. At this point the tool is in ‘delete key mode’. 5. The LED on the tool will flash ORANGE as it sends commands to the vehicle. After approximately 5 seconds, the LED on the tool will flash GREEN and beep five times to indicate there are zero keys programmed. 6. The tool will then light up RED/GREEN/BLUE and you will hear 3 descending tones to indicate the process has finished 

Any Questions Phone or Text 0789 647 8689 

SEE THE VIDEO BELOW ON HOW TO USE THE TOOL

just copy and paste this link in your brouser

https://www.youtube.com/watch?v=L3UOxBvGzUc&t=7s