Product Overview

DIY LED Upgrade Kit for GMT900 Instrument Clusters (2007–2014)

Upgrade the factory backlighting in your instrument cluster with this DIY LED replacement kit. These LEDs are designed to fit the factory circuit board used in GMT900 platform clusters.

⚠️ Important: This listing is for LED components only. No instrument cluster or additional hardware is included.

What You Are Purchasing

• 20 replacement LEDs (choose your color)

• Designed for GMT900 instrument cluster backlighting

• 17 LEDs required for installation

• 3 extra LEDs included in case of installation mistakes

Vehicle Compatibility

Designed for GMT900 platform vehicles (2007–2014) including:

• Chevrolet Silverado

• GMC Sierra

• Chevrolet Tahoe

• GMC Yukon

• Chevrolet Suburban

• GMC Yukon XL

Compatibility may vary slightly depending on cluster revision. Please compare your cluster with the listing photos.

Tools Required

You will need the following tools for installation:

• Fine-tip soldering iron

• No-clean flux and quality electrical solder (NOT plumbing type)

• Precision tweezers

• Plastic pry tool or similar

These LEDs are very small surface-mount components so proper tools are strongly recommended.

Skill Level

Recommended Skill Level: Intermediate electronics / soldering experience.

Installation requires:

• Removing gauge needles

• Desoldering factory LEDs

• Installing new surface-mount LEDs

If you are not comfortable performing this type of work, professional installation is recommended.

Basic Installation Overview

A number of YouTube videos demonstrate this process visually. Below is a simplified overview:

1. Remove the instrument cluster from the vehicle.

2. Remove the four silver screws on the back of the cluster.

3. Release the black push tabs to remove the gauge lens assembly.

4. Carefully remove the gauge needles using a plastic pry tool.

5. Remove the white midplate by releasing the clips.

6. Apply flux to the 17 backlighting LEDs.

7. Desolder the factory LEDs.

8. Install the new LEDs in the correct orientation.

9. Reassemble the cluster.

10. Test the cluster with ignition on before completing installation.

11. Verify needle accuracy.

12. Reinstall the cluster in the vehicle.

LED Orientation

Each LED has a notched side indicating the negative terminal.

Match the notched side to the negative marking in the provided instructions.

 Disclaimer

This product is a do-it-yourself (DIY) component kit intended for individuals with electronics and soldering experience.

By purchasing this kit, the buyer acknowledges that installation is performed at their own risk. If you are unsure about the installation process, professional installation is recommended. Seller assumes no responsibility for damage caused during installation