Product Description:
Model No.: Upgraded HSH pre-wired guitar pickup guard set
Material: Alnico 5 pickups, imported copper wire
Pickup Specifications:
Neck pickup: Alnico 5 humbucking pickup, DC resistance about 7.5KΩ, hole spacing 50mm
Center pickup: Single coil pickup, DC resistance about 9.8KΩ, hole spacing 52mm
Bridge pickup: Alnico 5 humbucker, DC resistance about 14KΩ, hole spacing 52mm
(Note: resistance values are for reference only and may vary slightly with temperature)
Electronic components:
Potentiometer: 3× CTS 500K
Switches: 4 × single-cut switch; 1 × enhanced function switch
Capacitors: 2 × orange capacitors
Output jack: 1 × output jack

Range of use:
Suitable for most ST type guitars, easy to install, just solder the reserved wiring to the guitar spring claw.
Weight:
Approx. 700g/set
Accessories:
Includes 11 mounting screws
Important Notice:
The product is covered with a protective film to prevent scratches and damage. Be sure to remove the protective film before installing it on your guitar.
Additional Features Description:
5-speed switch 1st position: only the neck pickup works. When the Enhancement switch is pressed, the neck and bridge pickups will operate simultaneously.
5-Speed Switch Second: The neck and center pickups will operate simultaneously. The neck, middle and bridge pickups will operate simultaneously when the Enhancement switch is pressed.
INDIVIDUAL SINGLE-CUT SWITCH: Each pickup is equipped with an independent single-cut switch. If the single-cut tone is poor, it is recommended that the compensation switch be used to optimize it.