Product description:

- 100% Brand New!
- Workshop Quality Coolant Filling Kit.
- Minimise coolant spills onto your workshop or garage floor using this filling kit.
- Kit comes with a range of radiator adapters, extension and elbow to suit a wide range of vehicles.
- Made from heavy duty plastic.
- Great for assisting in bleeding air out of cooling systems.
- Quality tool made in Taiwan.
- What makes this funnel performs so well is the small centre bleed tube that runs up through the centre plug handle, this allows air to escape during fill greatly reducing the chances of burping and improves air purging from the cooling system - the cheap copies now on Ebay dont have this feature.
- Also the centre plug handle is captive so you wont loose it.

Instruction:

1. First install the correct sized adapter into the correct cap. Place the gasket in a downward position. Tighten the cap with adaptor to make sure it doesn’t leak.
2. If 45° elbow or extension needed, place the funnel after elbow or extension is placed well into the adapter opening.
3. Fill funnel slowly and carefully with coolant about 1/3 full.
4. When run the engine with funnel attached, fluid level should be at low position. Keep RPM on idle position. (Shut down the engine if notice the fluid level rise excessively. Wait for fluid level go lower before restarting the engine.)
5. Use Fluid Stopper for remaining fluid inside the funnel to flow to the radiator hose by squeeze it and release.
6. After finish, remove the funnel ( and or extension/elbow) & adapter, close the radiator with cap tightly.

Warning:Do not open cap if radiator is hot! Hot fluid can erupt and cause burns!