I had a fellow pinsider give me one of these for my Pinball Magic and once I got it I though that since it is impossible to find that I would take it to my printer and see if he could make some so that others that were in the same boat as me (looking forever for one) could have the option for a reproduction since the originals are just not available.

My printer said this about the process:

Solvent Print on 3M vinyl adhesive with gloss laminate with bright chrome polyester overlay

So basically the chrome portion is precision cut and installed over top of the vinyl so has a bit of a 3D effect.

Take a look at the pics and you will see how much of an improvement it was on my Pinball Magic apron.

I removed the old decal pretty easily but pulling up a corner with a razor.

.