This Commander Gree design is similar to the design made by LEGO® years ago, with additional arm printing.

MINIFIGURE NOT INCLUDED - DECALS ONLY

This decal is intended for use on the same colour minifigure as seen in the images.

I imitated the dual-moulded legs look by painting the bottom half of each leg black.

Note - Decals will not show up on darker colour background, hence my choice of khaki green for the figure's legs and arms.

Instructions for use:

- Cut the decals to size, following the print outline very closely.

- Put the decals face side up on top of the water surface in a small container.

- Leave for 30-45 seconds, then remove the decal.

- Apply a small mist of water to the figure part, then slide the decal off of the paper backing onto the part.

(NOTE - the decal may need gently teasing off of the paper, in this case I would delicately insert a blade between the paper and decal and slide the decal off slightly, then complete the rest of the transfer using an application sponge or delicately using the tip of the blade on an area with no printing.

- Once the decal is in the desired place, use an application sponge to dry off the excess water. You may have to reposition the decal if it slides about during this step. Continue until most of or if not all water is gone.

- Once dry, give the figure parts a clear coat with some sort of aerosol varnish/lacquer and leave to cure as per the can instructions.

- Assemble your new custom minifigure!

If you want to buy multiple different decals from my shop, continue and add them all and I can offer a refund to account for the stacked postage fees upon purchase. (i.e. you will only end up paying one postage fee for all decals).

I hope you enjoy using my design!

LEGO® is a trademark of the LEGO Group of companies which does not sponsor, authorize or endorse this product.