一、Fitment
✅ Compatible with:
2004-2024 F150 (2WD/4WD)
- 2007-2015 Expedition
- 2007-2015 Lincoln Navigator
- 2006-2008 Lincoln Mark LT
二、Specification
Material: 36mm thick high-strength steel
- Ball Joint: Premium pivoting ball joints with dust cover
- Bushing: High-density rubber bushings
- Craft: TIG full-length welding
三、Note
Ball Joint: Grease before installation; dust cover prevents fluid/grime, extends service life
- Safety: TIG welding reduces bubbles/rupture risk; full-length welding boosts stability/structure
- Performance: High-density rubber bushings reduce noise/vibration, improve handling
- Ride Quality: Ball joints ensure safe, smooth ride & precise vehicle control
Product Description
-
Fitment
- 2004-2020 Ford F150
Will not fit 2010-2014 SVT Raptors or 2017-2018 Raptor models
- 2004-2020 Ford F150
|
|
|
|
|---|---|---|
|
High quality greasable ball joints with a protective cap to keep out dirt and debris. |
Fully TIG welding and lagerer diamter pipe improve and increase the strength of the suspension. |
Replacement the factory control arms,it will lift 2-4 inches for yourtruck and give your truck an aggressive look. |
Installation Steps:
- Jack up the car, get tire off. Take inner wheel off.Bend back a little to get enough room.
- Loosen the long bolt coming through 2 sides. Remove ABS line.
- Pull out cotter pin, loosen castle nut.
- Ball joint out by hammer.
- Remove sway bar end line from the spindle.
- Remove long bolt, wiggle old arm out.
- Install back new front upper control arm.
On Sep 18, 2023 at 00:43:28 PDT, seller added the following information:
On Feb 4, 2026 at 18:48:31 PST, seller added the following information: