Item Description

The Century Pool and Spa Pump Motor is a single-phase motor with a permanent split capacitor for enhanced running efficiency. Equipped with an auto overload protector and ball bearings, the Century Pool and Spa Pump Motor provides long-lasting operation. The Century Pool and Spa Pump Motor have a threaded shaft that allows for convenient and direct mounting. Available in horsepower ratings ranging from 1/2HP to 3HP, the Century A.O. Smith Pool and Spa Pump Motor comes in Full or Up-Rated models and provides long-lasting and trustworthy performance.

Please Note: When replacing the motor on the pump, replacing the mechanical pump seal is required to ensure proper installation. Pump seal size varies depending on the pump and not the motor.

• Auto Protector
• NEMA 56C Face Mount
• Open Dripproof
• Capacitor Start and Capacitor Start-Capacitor Run
• Rotation: CCW Pump End
• Sealed Ball Bearings
• Sealed switch design
• 1081 Design
• 50 C Ambient
• 60 Hertz
• 303 Stainless Steel Shaft

Installation Instructions:

• Ensure the pool motor is compatible with your pool pump.
• Turn pump power off during replacement.
• Check voltage requirements on your current setup.
• Always replace the mechanical pump seal. It's recommended to replace all gaskets when replacing the motor.
• Turn on the pump to test for leaks and pump operation.
• Please reference additional installation instructions in owner's manual in Guides and Documentation section below.
• Please Note: We recommend professional installation or the manufacturer warranty may be void. See Warranty section below.