Subli Vista Premium DIY Satin Sheen Sublimation Spray is specifically designed to allow the transfer of a sublimation image onto a non sublimation ready surface. Simply apply Subli Vista to your chosen products surface as directed and you will have a permanent Satin Sheen sublimation layer on which to transfer your sublimation image.

Subli Vista Satin Sheen sublimation spray can be used on most surfaces including; wood, glass, acrylic, ceramics, most metals, slate, stone, composite boards, in fact the list is almost endless. Subli Vista Satin Sheen sublimation spray is see through, should you require a white undercoat to give vibrancy simply apply Subli Vista White Brilliance Undercoat before the Satin Sheen.

Applying sprays directly onto hard surfaces such as glass, metals or ceramics may require the use of our Sublimation Adhesion Promoter, if you are unsure please email us with the details of your project, or use the contact form on this website.

How to Apply

Shake for 30 seconds to activate the product. Spray onto the substrate at 20cm spraying left to right and from top to bottom. Turn the substrate 90 degrees and repeat.

How to Cure

Once sprayed leave the substrate for up to 10 minutes then cure in an oven at 160C or 320F for 20 minutes depending on the thermal properties of the substrate. The product should be allowed to cool before pressing an image onto it.

Clean the Nozzle

After spraying turn the can upside down and depress the nozzle for 3 seconds to clean the nozzle for next use. This step is not required but will prolong the smooth spray life of your aerosol nozzle.