Features
1. Brand New; Durable; 100% CE High Quality.
2. Easily attachable to any 4 hole borden handpiece connector
Specifications for High handpiece
Characters
- Power Performance Reliability
- Steel Bearings
- Clean Head System
- Push Botton Type
- Single Spray
- Standard Head
Specifications for Low Speed handpieces
- E-type connector
- Push Button type
- Precise technology, Steady, no vibration while revolving, offering a steady operation.
- Suitable for any E-type handpiece accords with ISO standard
- 135°C Autoclavable, suitable for both steam and chemical autoclave
Contra angle handpiece
- Low Speed 22,000-27,000 rpm.
- The shank of the instrument mounted therein is 2.35 mm
- Fastening of the instruments with a turning latch
- Autoclavable 135°C
- For any lab or E-type motors
Straight Nosecone
- Working pressure: 0.3MPa ;
- 0.25MPa (Measure meter is installed at the end of air motor to measure the air pressure).
- Revolution: about 22000-27000r/min (adjustable between clockwise or anticlockwise)
- Noise: ≤68dB
Air Mortor
- Supply air pressure: 245-392KPa (2.5-4kgf/CM2)
- 1:1 Direct Drive
- 4 hole
Specifications for Air Scaler Handpiece
Available air pressure: 3.2 KG/c㎡
Sterilization: High-temperature (135 Degree) and High-pressure repeatedly
Available Air Pressure: 2.5~3.5KG/c㎡
Air Pressure: 2.8KG/c㎡
Air Volume: 15~24L/Min
Sound Level: 65-68 dB
Net weight: 0.12kg
Gross weight: 0.15kg
Packing size: 170*80*30MM
Material: Metal
Caution
1. The air supply must be free of moisture. The water supply must be filtered.
2. Place the most priority of the patients safety
3. Do not exceed 0.28Mpa(2.9kgf/cm2)when setting the air pressure at the dental unit.
4. If any abnormalities are found in use, stop using immediately and contact your dealer.
5. Do not drop, hit, or subject to excessive shocl.
6. Check the vibration, noise and overheating outside of the patient's
mouth before initial use. If any abnormalities are found in use, stop
using immediatel and contact your dealer.
7. Be sure to stop the air supply, and replace the tip ro the coupling joint.
8. Watch out the sharp point of the tip.
9. Do not use a spray lubricant. Limited air discharge orifice size of
the scaler forces the propellant pressure to build up inside, and the
scaler may fly off.
10. Do not clean or wipe the scaler with highly oxidized or acid water or strilizing solution.
Packing List:
- 1X high speed push button clean head pieces 4hole compatible with NSK PANA MAX
- 1X Air Scaler Handpiece 4 hole with 3 tips
- 1X NSK Style contra angle with blue band
- 1X NSK Style strainght angle piece
- 1X NSK Style air motor 4 hole