3D PRINTED Logitech G29 Quick release system for Aftermarket Steering Wheels! DIY. Condition is "Brand New". Sent with Australia Post Standard Parcel.

With this system you can attach aftermarket rims with no problem.

Parts needed:( REQUIRED) TO ASSEMBLY
Bicycle Seat Post clamp with the diameter of 34.9mm
Screws for Wheelbase and Aftermarket Wheel


Size 1: Logitech screw holes (inner holes)
Size 2 :Aftermarket Steering wheel screw holes (outer holes)

Installation:


Part 1: Part where the clamp gets attached(picture number one)
Part 2: Part that goes onto the wheel (Picture two)


2.) Screw Part one onto the Wheelbase
3.) Screw Part 2 onto the Wheel
4.) Attach the bike clamp to Part 1
5.) Put Part 2 into Part 1
6.) Tighten the clamp
7.) Enjoy!


Some slight sanding may be needed as it is a very tight fit.