Exact item shown, Tek current probe 6022.  

The manual for this probe is located here: https://www.manualslib.com/manual/1317744/Tektronix-P6022.html?page=2#manual

The table below shows the frequency response from the manual.  The Tek probe comes as a kit with a special termination component that lets you adjust gain.  This listing contains the probe only.  As shown in my scope photos, you can use the probe without the Tek  termination and you can make an RC termination block to provide appropriate termination/damping and eliminate the ringing you seen in my scope traces (the ringing is from the inductance of the probe and the capacitance of the cable).

I tested this P6022 and photographed the actual test setup and results. I used my scope's calibration signal as the test source. Each test sequence shows a test setup and then the results.  First I tested the probe alone with the calibration voltage going straight to ground through a thin test lead that the probe could clamp around. A sequence of photos shows positive- and negative-going pulses associated with the rising and falling edges of the square wave.  I tried to synchronize the yellow current  probe output with the blue voltage from the calibrator output but the short to ground through the test lead going through the probe pulled the voltage too low and I couldn't reliably trigger on it. The final photos show the calibration voltage (blue) and P6022 output (yellow) together; with a 1 kΩ series resistor to reduce the load on the calibration output so I could trigger on that square wave, the square wave is clearly visible along with the P6022's current pulses at each transition. The probe is responding properly to changing current.

Note to me: 5th thin drawer

I normally ship within 24 hours of your order, but the post office does not always initiate tracking when I put the packages in the drop off box.  

Check out my other items!