Solder these 8BitFlux Kits yourself, learn about electronics and enjoy short circuit protection. The kits include the PCBs, all parts, breadboard, full schematics and bill of materials. Use it for educational purposes, custom prototyping, experiments with (vintage) computers and for fun with TTL logic or microprocessors.



The jumper wires, the IC on the breadboard, USB cable and 9-volt battery that are visible in the pictures are not part of this offer and are meant for illustration purposes. All tiny parts come pre-soldered on the PCB.


Super Breadboard 2

Enjoy short circuit protection, indicated by the red LED. The (protected) voltage can be selected using a jumper (+5V or +3.3V). It can be powered by the USB-C port, or this connector can be used as a breakout in your experiments. Power can also be supplied with a (9-volt) battery, ranging from 6.5 to 12V. The +3.3V is derived on the +5V and regulated on the board itself. Switch to a custom supply when the +12V and -12V rails are needed as well (these are unprotected voltages).


An optional Logic Probe (as a kit) can be attached to the left- or right-hand side of the board. Use the spring-loaded pogo pin to touch points in your circuit (or the output-legs of a logic IC) to check their logic values (high, low or float).


The board provides a clear separation of input (at the bottom) and output (at the top). Handy for (low-voltage) TTL, Arduino, ESP32, ESP8266 and LVCMOS experiments. Also for vintage computer experiments where an 8-bit bus is involved. Two parts are always ready to use: a button and a LED (with resistor).


All signals can be bridged using jumpers. For example: the four high-nibble input-bits can be tied to the output when they are not used on the breadboard. Super Breadboards can be chained vertically to do larger experiments. They propagate their short circuit protection downwards.



Terrific Timer

Explore one of the most popular and widely used ICs: the 555-timer. Two of them are on this board, one for each mode of operation. A bistable latch enables start and stop of the clock (astable mode). Turn the frequency dial to adjust the speed. When stopped, a step button generates a pulse (monostable mode). Insert your own parts (capacitors and resistors) and be free to customize either mode. For example, create a 1 kHz astable clock or a 30 seconds monostable pulse.

See the last picture with an attached Super Breadboard (does not come with this offer) of this 8-bit Workbench line of products, a great way to experiment with it further. Or use the clock-output with your own breadboard for prototyping (e.g. create a counter with a 74LS393). Create sequential timers by using a second board as trigger-input. Why not create your own computer with it? ;-)


Logic Probe


The Logic Probe is designed and made by MitchElectronics Ltd. from the UK. All the documentation can be found online.

Instead of having numbers to show voltages or a display to show signals over time the logic probe has just three LEDs for outputs. These outputs can show the following conditions:



Item comes with a male JST cable (20 cm length) and a small heat shrink tube for easy connection.




An optional 8-bit Workbench™ can be attached at the top. With this you have an annotated 8-bits binary LED display. It talks hexadecimal and octal. A clicky Digitast action-button provides a properly debounced signal for use with microprocessors. With it you can further learn about logic and see how number systems work. For binary data-input, a Binary Keyboard or Hex Keyboard can be attached at the bottom. 




Search the web for more documentation, which is available. 



Questions? Just ask!


Worldwide tracked (not insured) shipping! This includes shipping to the USA.