Reproduction Zenith 36IV carburettor to fit Land Rover 2.25 petrol engine, original fitment to Series IIA and III 1967-85. Can also be fitted to Series II / IIA 1958-67 in place of the original Solex PA40 carburettor but you will need to source a manifold adapter, throttle bellcrank and a couple of linkage parts as well as a longer choke cable.

These Chinese reproduction carburettors have gained a poor reputation but this is almost entirely down to a poor quality O-ring between the two body halves. The quality of the castings and machining, at least on the Allmakes-branded ones that I sell, is pretty good. I strip each carburettor, inspect it internally and replace the O-ring with one made from Viton which resists modern E10 fuel very well. I also check/adjust the float height setting and open out the main jet very slightly as I have found that on E10 or even E5 these carburettors tend to run a bit lean on the standard jet size. Finally I replace the stupid tamper-proof idle speed screw with a conventional screw and friction spring so you can adjust the idle speed without needing a special tool.

Shipping via Tracked 48, 12 months warranty. I have about 30 years experience owning and working on these vehicles so if you run into problems you can contact me and I will do my best to help. Occasionally you get a 36IV which just won't run properly whatever you do with it: this happens with genuine carbs, even expensively rebuilt ones. Provided you get one which works out of the box (most of them do) it will carry on working for a very long time.