Properties:
1. The controller is controlled by a single chip microcomputer, and the output pulse is accurate to ensure the welding quality. Can display welding parameters with the LCD screen.
2. A 10AWG flexible multi-filament wire is used for the weld pin lead and input lead to increase the overcurrent capacity.
3. The control is mainly used for welding nickel-plated steel strips from 0.1 mm to 0.15 mm.
4. The welding pin and input lead are connected by U-shaped cold-pressed clamps, which is convenient for disassembly and replacement.
Spot welding machine set only, other accessories demo in the picture is not included.
Instructions for use:
1: The controller comes with a 20 cm 10AWG input cable. One end was crimped with a U-shaped connector and the other end was left untreated. Connect the crimped U-shaped connector to the control power input connector, and the other end will be processed according to its own power supply. Do not connect the negative electrode incorrectly.
2: There is a power switch under the control board. After pressing, wait 3 seconds. After the buzzer sounds, the LCD lights up and the start-up process is complete. Press the power button again to shut down the device.
3: Screen description and parameter setting.
4: Keep the welding pen clean. If the welding pin is polished into a round head, the welding effect can be improved. There are manual and automatic methods.
Specification:
Length of the input line: approx. 22.5 cm
Length of the welding pin: approx. 40 cm
Quantity: 1set
Package contents:
1Pc x controller
1Pcs x power input line
1 piece x welding pin
1 pair x U-shaped cold-pressed clamp

