This high voltage bleeder is actually two high voltage resistive dividers that share common ground. This allows for accurate measurement of both anode and cathode KVP measurements of X-Ray systems. Using a dual-channel oscilloscope in the differential mode, this can be used to accurately display up to 160,000volt waveforms. The divider ratio is 1000:1. Aside from being used for calibration of generators, this bleeder is invaluable for troubleshooting high voltage breakdown anomalies. As shown in the images, included are two, (2), five-foot high voltage cables, (note that all the pins are intact), a shielded oscilloscope test cable with banana plugs, four silicone dielectric pin insulator discs, tube of HV dielectric insulation grease, Bleeder manual.