🟢 The spindle is made to use with a Baldor Polishing motor. 🟢 Spindle is fits 3/8" Polishing lathes has an inside diameter that is tapered to fit on the tapered shaft of a Baldor Polishing motor. 🟢 These are specifically made to fit Baldor motor shafts since they are not straight, but have a slight taper. 🟢 Spindles are a friction fit, they are pushed on to the shaft of the Baldor motor, to properly secure them onto the shaft, lightly tap with a soft mallet or a piece of wood. 🟢 To remove, just use the screw off spindle remover on the motor by simply unscrewing and turning it until the spindle is pushed off of the tapered shaft. 🟢 Spindles is made of cold rolled steel is machined to close tolerances, made in U.S.A. 🟢 Spindle has a 3/8" Tapered arbor hole to work on the Right Side of Baldor 3/8" shaft motors. 🟢 The spindle arbor hole has a slight tapered to fit and be held on the Baldor Motor Lathes Right Side shaft. 🟢 Note: Spindle does not have tightening screws.
🔸 Precision Quality 🔸 Machined - High Speed Lathe 🔸 Made from 3/4" Stock Material 🔸 Material: Cold Rolled Steel 🔸 Overall Length: 3-1/2" - 90mm 🔸 Spindle Body Length: 1-3/8" - 35mm 🔸 Spindle Tapered Length: 2" - 51mm 🔸 Arbor Hole: 3/8" Tapered Friction Grip to Shaft 🔸 Weight: 2.75oz. 🔸 Spindle is made to be used on a 3/8" tapered shaft diameter and on the Right-Hand Side of Motor with forward direction.
🟢 Machined - High Speed Lathe 🟢 Made from 3/4" Stock Material 🟢 Material: Cold Rolled Steel 🟢 Overall Length: 3-1/2" - 90mm 🟢 Spindle Body Length: 1-3/8" - 35mm 🟢 Spindle Tapered Length: 2" - 51mm 🟢 Arbor Hole: 3/8" Tapered Friction Grip to Shaft 🔻 For more information check detail page 🔻