Stop paying overpriced Ebay prices on vintage Transformers parts! I did it for you. But, I did it so I could make exact replicas of the original pieces and make you much cheaper 3D RESIN printed alternatives. None of those annoying lines you get with filament printing. These are smooth like the originals, and I try my best to color match them with the resin so that you can't tell the difference. These parts look and work just like the originals.

 

You get replacement of all parts, feet, legs, 2 red wings 2 grey fins, blue blaster, sword. helmet w/ spike

ALL PIECES AVAILABLE INDIVIDUALLY AS WELL! JUST MESSAGE ME TO PLACE AN ORDER! CHECK OUT MY OTHER AUCTIONS TO SAVE EVEN MORE MONEY ON REALLY HARD TO GET PIECES!

All sales are made to order. It can take a day or two to get pieces printed and cured and finished ready to ship out. 

!!!!IMPORTANT!!!!!

I test each piece as I made them, and test them again for fitting once you place your order. But all of our toys are a little different depending on their past life as a well played with toy. I base pieces on my figures in my collection. Yours might very well be different slightly-- specially the soft plastic pieces. If you get a piece that is a little too tight, GENTLY, with even pressure twist the peg back and forth into the whole. Just a slight twist back and forth. Not all the way around. The resin will start shaving off and it'll soon be to your perfect size. If it's too loose, a dab of super glue or clear nail polish will do the trick.  You can also run these pieces under hot water for a minute to get them to be a bit softer and more malleable and easier to work with without making it brittle. Remember, while I do use ABS-Like resin, it's still resin, not plastic, and can snap if uneven pressure is applied. If a piece does break I'm more than happy to help you replace it for free, just help cover the shipping costs, because no one likes broken stuff.