Specification
Access capacity
- Two ports:
- one dedicated 100/1000BaseX (SFP) port
- one 10/100/1000BaseT or 100/1000BaseX (SFP) port
Network interface
- One 10/100/1000BaseT or 100/1000BaseX (SFP) port
- Two 100/1000BaseX (SFP) ports
- Two 10/100/1000BaseT or 100/1000BaseX (SFP) ports
- One network port can be defined as an additional access port
Network interface redundancy
- IEEE 802.1AX link aggregation - active/standby or load balancing
- ITU-T G.8032 Ethernet ring protection
Synchronization
- ITU-T G.8261 /G.8262 /G.8264 Synchronous Ethernet on all interfaces
- Sync status message support
- IEEE 1588v2 Precision Time Protocol
- ITU-T G.8265.1 and G.8275.1 PTP Telecom Profile
- BITS-in and BITS-out
- BITS sync status messaging
- 1 PPS in/out
- 10MHz
VLAN support
- 4096 VLANs (IEEE 802.1Q customer-tagged) and stacked VLANs (Q-in-Q service provider tagged)
- 2-tag management (push/pop/ swap) for c-tag and s-tag
- IEEE 802.1ad provider bridging (c-tag, s-tag)
- Ethertype translation
- 8 1,2 / 32 3-5/ 64 6-10 Ethernet virtual circuits (EVC)
- 9612 Byte per frame MTU transparency
- EoMPLS encapsulation
Layer 2 traffic management
- Acceptable client frame policy: tagged or untagged
- Service classification based on IEEE 802.1p, 802.1Q and IPTOS/DSCP
- VLAN tag priority mapping (IEEE 802.1ad PCP encoding)
- MEF-compliant policing (CIR/CBS/EIR/EBS) with threecolor marking and eight classes of service
- Port shaping on transmit for both client and network ports
- MEF 10.3 hierarchical policing with token-share envelopes
- DiffServ supporting WFQ/SP mix
Layer 3 traffic management
- L2-L4 access control lists (ACL) for classification
- VRF-lite virtual routing and forwarding supporting IPv4 and IPv6
- BGP and OSPF dynamic routing
- DHCP relay agent
- DCSP remarking
Operation, administration and maintenance (OAM)
- IEEE 802.3ah EFM-OAM link management
- IEEE 802.1ag connectivity fault management (CFM) with hardware assistance
- ITU-T Y.1731 performance monitoring
- ITU-T Y.1564 service activation testing
- Terminal and facility loopbacks on port- and EVC-level for all interfaces
- Cable diagnostics with benchmarks (electrical interfaces only)
- Embedded RFC 2544 test generator and analyzer (ECPA)
- MEF-compliant Layer 2 control protocol disposition and extensive filter options for Layer 2 packet types
- Link loss forwarding to signal local link and network path failures
- Dying gasp message for power failure alarming (EFM-OAM and SNMP trap option)
- Port mirroring (local and remote)
Performance monitoring
- RFC 2819 RMON Etherstats on a per-port and per-service basis
- 15-minute and 1-day performance data bins
- IEEE 802.3ah/ITU-T G.8021 PHY level monitoring
- ITU-T Y.1731 single- and dual-ended frame loss measurement
- Synthetic frame loss and delay measurement for multipoint service monitoring
- TWAMP sender/reflectors for L3 based service assurance
- Multi-CoS monitoring on EVCs scaling up to 32/ 64/ 128 simultaneous SOAM flows
- Threshold-setting and threshold-crossing alerts
- Physical parameter monitoring for SFP optics, including TCAs
- Temperature monitoring and thermal alarms
ConnectGuard security
- L2 MACsec encryption at line rate on a per-EVC basis
- End-to-end encryption mode with one or two VLAN tags transmitted in the clear
- Robust AES encryption algorithm (AES-128 /AES-256)
- Key distribution based on IEEE 802.1X
- Diffie-Hellmann key exchange process (2048 / 4096 bits)
- Tamper resistant and evident enclosure
- Full interoperability with all FSP 150 ConnectGuard enabled products
Low-touch provisioning
- DHCP/BOOTP auto-configuration
- IEEE 802.1x port authentication (supplicant and authenticator)
- Text-based configuration files
- TFTP/SCP for software image upgrade and configuration file copy
Management and security
- Local management
- Serial connector (RJ45) using CLI
- Local LAN port (RJ45) using CLI, SNMP and Web GUI interfaces
- USB (Type B Micro) using CLI1
- USB (Type B Mini) using CLI2
- 3G/ LTE/WiFi USB interface
Remote management
- Maintains in-band VLAN and MAC-based management tunnels
- Fully interoperable with other FSP 150 products
Management protocols
- IPv4 and IPv6 DCN protocol stacks, including dual-stack operation and 6-over-4 tunnels
- Telnet, SSH (v1/v2), HTTP/HTTPS, SNMP (v1/v2c/v3)
- NETCONF/YANG, OpenFlow
Secure administration
- Configuration database backup and restore
- System software download via FTP, HTTPS, SFTP or SCP (dual flash banks)
- Remote authentication via RADIUS/TACACS
- SNMPv3 with authentication and encryption
- IPsec on management traffic
- Access control list (ACL)
IP routing
- DHCP, RIPv2 and static routes, ARP cache access control
System logging
- Alarm log, audit log and security log
Environmental
- Dimensions (W x H x D): 443mm x 44mm x 208mm/17.4 " x 1.7" x 8.2"
- Operating temperature:
- 0°C to +45°C/ 32°F to 113°F
- -40°C to +70°C/-40°F to 158°F (hardened environment)
- Storage temperature: -40°C to +70°C/-40°F to 158°F (GR63-CORE)
- Humidity: 5 to 95%, B1 (non-condensing)
- Power supply:
- Fixed, redundant PSUs, 110/240VAC, -36 to 72VDC with over-voltage and over-current protection
- PSU5,8-10: 110/240VAC, -48 to -72VDC or +24 to +30VDC with over-voltage and over-current protection
- Power consumption:
- Nominal: 6.5W1, 12,5W 2, 19W3,4, 21W5, 23W6,7, 24W8,30W9
- Maximum: 10W1, 15W 2, 23W3,4, 25W5 ,28W6,7, 29W8,35W9
- Dry-contact environmental alarm inputs