The Ford Mach-E 12v battery is hidden under covers in the frunk without easy access. A common solution is to drill holes through the plastic so that the battery can be charged or "jumped" without dismantling the frunk panels.
These plugs come as a pair and fit into a 2.5" hole that you drill through the plastic cover. The access hole plugs click in and are easy to remove. The 2.5" hole size makes it easy to get jumper cables onto the terminals below (which are marked on the plastic.)
The positive terminal hole plug is black with red text.
The negative terminal hole plug is black with white text.
*If you want another color set, message me after ordering*
Color options:
- Both Black plugs with white text (positive and negative)
- Black NEG with white text + Red POS with white text
- Black NEG with white text + Red POS with black text
- Black NEG with white text + Black POS with Red text
*Note* You will have to drill your own holes using any 2.5" hole-saw which can be purchased at any big-box hardware store.
Printed instructions included
- Take the panel that covers the battery out of the Mach-E frunk and prepare to drill holes away from your Mach-E. (do not drill holes into any panels while the panel is attached to the vehicle as you may cut or damage something that rests below the panel)
- Measure 1 3/8" to the right of the negative symbol on the panel - and make a mark.
- Measure 1 3/8" upward and to the right (45 degree angle) of the positive symbol on the panel - and make a mark.
- Carefully drill pilot holes at your marks. This will be the center of the 2.5" hole.
- Carefully drill the 2.5" holes using a 2.5" hole saw.
- Once the holes are cut, place the access plugs into the holes and place the panel back into the car.
Drill and hole saw not included.
Dimensions:
2.5" (63mm) diameter
These access hole plugs are 3d printed from ABS plastic which can handle the hot temperatures that might be found in your Mach-E.
Made in the USA.