Safely balance your hybrid battery cells. Made for 40 cell  hybrid batteries. 1/4" ring connectors are soldered to 14 awg wires and sealed with colored heat shrink. These fit the battery cells lugs perfectly. Has a disconnect plug between the two sides of the wires so there is no chance of grounding the cells out if installed correctly. Put the red wires on the positive terminals and the black wires on the negative terminals, hand tighten the nuts to the battery cell lugs. once the two wire halves are secure to the battery you can connect the center plug to start the balancing process. This usually takes 12-24 hours to fully balance the cells. Before removing the wires from the battery cells, it is very important to unplug the center connector.

These are well built and easy to use.

instructional videos are on our you tube channel.

fixnflip

We can build custom sizes for any vehicle or application, message us for a quote.

A couple issues we are seeing people have are shorted battery cells in their batteries which will cause sparks when the cables are connected together and also not having the nuts tightened can also cause arcing or sparks. Using a multimeter and set it to ohms or continuity setting and test between the positive and negative of each cell and see if there are any that show a short. If there are shorted cells they need to be replaced before trying to balance.

Pictures are of the 28 cell cables, the 40 cell cables look exactly the same with more connections.