This furnace is in good physical and relatively clean condition.  Because it runs on 220 volts, this furnace was not able to be tested.  It was taken from a working environment, a medical equipment company that suddenly shut down.  

   Reduce energy consumption and increase heat-up time with this furnace, ideal for general lab use.  The furnace is ideal for ashing most types of organic and inorganic samples, heat treating small steel parts, performing ignition tests and conducting gravimetric analysis, as well as for the determination of volatile and suspended solids.  

Digital single setpoint temperature control to 1100°C

Single display shows actual temperature or setpoint

Ceramic fiber insulation permits faster heatup, reducing energy consumption

Embedded heating element on top and both sides improves temperature uniformity

Drop-down door doubles as a shelf for loading and unloading

Door safety switch stops power to heating elements when door is opened

Thermocouple break protection cuts power to heating elements, preventing a thermocouple failure runaway condition

Specifications

Capacity (English)   0.07 cu.ft.

Certifications/Compliance    CSA approved

Depth (English) Interior    6 in.

Depth (Metric) Interior    13 cm

Description    FB1410M

Dimensions (D x W x H) Interior    6 x 5 x 4.25 in. (13 x 12.7 x 10.8 cm)

Dimensions (L x W x H) Exterior    15.8 x 10 x 14.5 in. (40 x 25 x 37 cm)

Electrical Requirements    240 V 50/60 Hz

Frequency    50/60 Hz

Height (English)    14.5 in.

Height (English) Interior    4.25 in.

Height (Metric)    37 cm

Height (Metric) Interior    10.8 cm

Length (English)    15.8 in.

Length (Metric)    40 cm

Power Consumption    1520 w

Temperature Stability    ±0.5 at 1000°C (±5.0 at 1000°C)

Width (English)   5 in.

Width (Metric)    25

Width (Metric)    Interior12.7 cm

Capacity (Metric)   2.1 L

Temperature (Metric)   100°C to 1100°C

Type   Single Setpoint

Voltage   240 V