Used International IHC Hand Corn Sheller Feed Table

This is an original Feed Table / Hopper for International hand-crank standing corn-shellers.

Very hard to find these anymore & most International shellers have them missing.

It bolts to the top casting by the 2 bolts. (most of those casting have a part number of " IHC 2344 ").

The end has been re-cut and the 2 bolt holes (5/16") have been re-drilled. So it is a bit shorter than originally.

(Some of these IH shellers had either 5/16" or 3/8" bolts & corresponding sized holes drilled in these feed tables. If desired you can easily drill the holes out to 3/8", but I would used the 5/16" bolts till the feed table holes wear oblong again. Then drill out to 3/8".)

Fairly straight. 

This is used so there are dents/bumps as seen in the photos.

Bolt holes are in really good condition.

There are two 5/16" bolts included with washers and square nuts.

Used item sold as-is. No returns on this item, so make sure it fits you application.

If questions, please ask.

No returns on this item.

Shipped via UPS ground delivery. 

Even though these don't weigh much, they have some size to them, so shipping will appear & will be high.

ref no.  79-39