06-08 Dodge Ram 1500 Mega Cab(only) and 03-09 Dodge Ram 2500, 3500, 4500, 5500 trucks with power seats. This kit also comes with the small steel worm as shown in the picture. Steel on steel makes more noise, so if you want a factory small nylon worm, see my other listing. Both types come with a lifetime warranty for gear breakage.
This is not used, but brand new. It will work for the front up/down adjustment motor. The factory front up down motor has a metal casing and a white end cap. The shaft is shorter than the rear up down motor, so please verify the motor you need. Replaces factory gear for motor part number:
Gen II B
Vertical
8-82991 or L0110346AA01
5609780
or 5719240
I sell both vertical motors on ebay. If you need the other, please check out my other auctions.
You will have to reuse your tube nut off the old shaft. The factory constant section ring must be removed from the old shaft in order to unscrew the tube nut. The constant section ring is a thick piece of wire that holds a bushing on the shaft end. If removing the section ring becomes a problem, you can cut the old shaft close to the motor and unscrew the tube nut from the cut end. This is the method I prefer.The screw holding the tube nut on the new shaft is left hand thread. A small socket can be used to tighten it, but you might have to spread the ends apart some. This won't affect the operation of the motor assembly.
Detailed install instructions with photos are included.
Check out my feedback to see other buyers comments on these motors.
Refunds: Unit must not be damaged or altered.
Please contact me with
any questions.
2men1garage