The Range Infinite Burner Switch for Frigidaire (part numbers: 316238202, PS12584881, AP5325508) is a common replacement part for Frigidaire, Electrolux, and other compatible ranges. Below are the specifics, troubleshooting tips, and installation instructions for this part:

Specifications:

• Part Numbers: 316238202, PS12584881, AP5325508

• Compatibility: Designed for Frigidaire, Electrolux, and other compatible ranges.

• Function: Controls the power supply to the infinite burner, allowing for precise temperature adjustments.

• Type: Infinite burner switch (also called an infinite control switch or simmer switch).

• Voltage: Typically rated for 120V.

• Terminals: Usually has 3 or 4 terminals, depending on the model.

Troubleshooting:

If your burner is not functioning properly, the infinite burner switch could be the issue. Here are some common symptoms and troubleshooting steps:

1. Burner Not Heating:

   • Check if the burner is receiving power.

   • Inspect the switch for visible damage or burnt terminals.

   • Test the switch with a multimeter for continuity.

2. Burner Not Adjusting Heat:

   • If the burner stays on high or low and won’t adjust, the switch may be faulty.

   • Ensure the knob is turning smoothly and not stuck.

3. Intermittent Operation:

   • Loose wiring or a failing switch can cause intermittent operation.

   • Tighten connections or replace the switch if necessary.

4. Testing the Switch:

   • Disconnect power to the range.

   • Remove the switch and use a multimeter to test for continuity between terminals as you turn the knob.

   • If there is no continuity or inconsistent readings, the switch is likely faulty.

Installation Instructions:

Replacing the infinite burner switch is a straightforward process. Follow these steps:

Tools Needed:

• Screwdriver (flathead or Phillips, depending on your range)

• Multimeter (for testing)

• Needle-nose pliers (optional)

Steps:

1. Disconnect Power:

   • Unplug the range from the electrical outlet or turn off the circuit breaker to ensure safety.

2. Access the Switch:

   • Remove the back panel or control panel of the range to access the burner switches.

   • This may involve removing screws or knobs.

3. Remove the Old Switch:

   • Take a photo or note the wiring connections to ensure proper reinstallation.

   • Disconnect the wires from the switch terminals.

   • Unscrew or unclip the old switch from the range.

4. Install the New Switch:

   • Position the new switch in place and secure it with screws or clips.

   • Reconnect the wires to the appropriate terminals (refer to your photo or notes).

5. Reassemble the Range:

   • Reattach the control panel or back panel.

   • Secure any screws or knobs that were removed.

6. Test the Switch:

   • Restore power to the range.

   • Turn the burner knob to ensure the burner heats up and adjusts properly.

Additional Notes:

• Always refer to your range’s user manual for model-specific instructions.

• If you’re unsure about electrical work, consult a professional technician.

• Ensure the replacement part matches the original part number for compatibility.

By following these steps, you should be able to troubleshoot, replace, and install the infinite burner switch for your Frigidaire range.