Stainless steel guitar knobs - each one lovingly machined using old school methods in Lancashire.

I will be adding more designs as I go along.

They are suitable for 6mm pots which are by far the most common. Please note they will not fit 1/4" pots which are 6.35mm.

Each one secures with a stainless grub screw.

3d printed knob puller also available, just add to basket along with the knobs. I strongly recommended that you use a knob puller to remove your old knobs.

In the pics you can see my Ibanez modelling a pair of smooth/plain ones. I didn't polish these and used them as they came off the machine so they aren't quite as bright. If you want yours unpolished let me know.

The underside is machined out with some nice detail to ensure the knob clears the locking nut on your pot.

The bottom of the 6mm hole is milled flat rather than a drill point to help make sure the knob sits flat and turns concentric on the pot.

When fitting just nip the grub screw with a 2mm allen key (not supplied) - don't overtighten the grub screw, if you round it off it will be a pain to remove.

If you have split pots line up the grub screw with the split. After fitting make sure the knob turns concentric, if it looks like it is wobbling up and down try again until you get it level.

Models so far

1. Smooth.

2. 4 spiral flute - these have 4 different flutes starting at different points on the knob.