DC 3V-24V 5A Flip-Flop Latch Switch Module Bistable Single Button for LED Relay

Functions and features:

1. Falling edge - triggered. Initial state after power no voltage output, once triggered, output terminal output the power supply voltage , after once again trigger the output terminal no voltage output, and so on.
2. Low standby power consumption, high output power, good anti-jamming performance optocoupler isolation.
Electrical parameters:
Power supply voltage: DC 3V-24V;
Standby current: less than 2uA;
Allowing continuous output current:
5A (when the power supply voltage 5V-24V);
4A (when the power supply voltage 4V-5V);
2A (when the power supply voltage 3V-4V).
Size: free pin size 16mm × 10mm × 7mm. Pin pitch 2.54mm.
Uses: LED electronic switch.
Note: The drive inductive load, the load to the appropriate freewheeling diode in parallel to avoid damage to the switching elements of the circuit.
Pin definitions:
VCC: power supply;
VO: output;
Tg: trigger signal input terminal;
GND: power ground.
Application:
 hu0504-4
 
Package Included:
1x Flip-Flop Latch Switch Module
 
We accept payment by PayPal only.
Payment must be received within 7 days after auctions ended.
Items will be shipped within 1-2 business days when we received payment.
Shipping to USA takes about 8-15 days in normal condition,other countries takes about 15-35 days.
Please verify your eBay primary shipping address. We are not responsible for any wrong or undeliverable addresses.
All items will be checked before packing
Your feedback and 5 star ratings are much appreciated.
If you are unhappy with your purchase, please contact us on negative / neutral feedback or low star ratings.
If you receive an item is damaged or defective, we will refund you or replace it with identical one.
All damaged or defective items may be exchanged within 30 days.
We take full responsibility if you receive wrong item or damaged item or item not as describled.
If you're not satisfied for any reason, please feel free to contact us. Just send us an eBay message.