- Condition: 100% new
- Color: Black & Red
- Material: Copper & ABS
- Size: As picture shows
- Practical Current: 500A
- Instantaneous Current: 700A
- Working Voltage: 12.6~16.8V
- Item included: 1 x Alligator Clamp
- Compatible With: fit for most car jump portable starters
-
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
Product Dimension:
Feature:
1) Made of high-quality copper, ABS plastic shell, and thickened silicon wire as raw materials. It has good conductivity, water resistance, and wear resistance.
2) The red clip is the positive electrode, while the black clip is the negative electrode. Two clear colors make it easy for you to distinguish.
3) The end of the battery clip has a groove pattern, which can effectively increase friction and make the clip easier to grip and use.
4) Short circuit prevention: The positive and negative terminals of the battery clamp with electrical short-circuit protection. When the positive and negative clamps are connected together, it will automatically disconnect.
5) Anti reverse charging: This product can prevent emergency power reverse charging of car batteries, so you don't have to worry about the car's power becoming less and less.
6) Anti reverse connection: When the two are accidentally connected incorrectly, the starter power supply and positive and negative clamps will automatically cut off to ensure safety.
7) Anti over discharge: When the starting power circuit is too low, this product will issue a reminder, and if it starts again, it will damage the power supply.
8) Anti overcurrent: If the starting power supply current is too high when starting the car, this product will issue a reminder and terminate the operation, which can effectively protect your car and power supply.
9) Timed out disconnection: After successfully starting for 3 seconds, the product will automatically disconnect. It can effectively protect your battery and personal safety.
How to Use:
1) Add the red clamp to the positive terminal of the car battery and the black clamp to the negative terminal of the vehicle battery.
2) EC5 plug for emergency starter power start port.
3) The battery clamp work light alternates between red and green, indicating correct connection.
4) Within 30 seconds after the battery clamp is properly connected, turn to the car and start the car. Before starting, please turn off the air conditioning, audio, and high-power electrical equipment; some cars need to turn on their headlights before starting.
5) Within 30 seconds of successful startup, please release the battery clamp from the car battery.
