Class 1 carrier based draughtproofing for use on internal and external doors

High Quality Schlegel Q-Lon Seals

1 x 1.025m Strip

35 Galvanised Pins

Easy to fit with basic diy knowledge and hand tools.  

Trim to size using either gasket shears, anvil action secateurs or fine toothed saw (hacksaw)

Offer up to the closed door and when touching the door push forward approximately 1mm and pin along its length.  (Adding extra pin in the corners if required.)

If a weather bar is fitted you will normally seal up to the point  level with the top of this.  (file the carrier to prevent any exposed sharp edges) 

It is recommended to fit rebate seal in the area the weather bar is and fit a draughtproof brush at the bottom of the door where possible.

Any advise or further information required please send a message