Version 2.0 released! Better looking and more sturdy than before!
Replace the factory non-push button hood release with a push
button.
Easy to install 2-piece design. Mix and match colors for buttons and mounts. The green is darker than the John Deere green. Yellow is a pretty close match.
Direct
replacement and takes about 5 minutes for installation. Simply remove
the old, install the new, tighten nut, push hood rod into
button.
Fits most 2017+ 3033, 3038, 3039, 3045, 3046. It only fits those with the side grill mount, not front.
**Notice:
This is 3D printed and some natural blemishes can result on the final
product and no two will look identically the same. We do our best to
provide top quality products however and do our best to ensure you're
getting something of good quality. **
 |
 |
 |
| Hood Latch Release Button | Throttle Lever / PTO Lever | 4 Wheel drive "kick" pedal Differential Lock Pedal |