TCI - DC JOLLY MD (122260) - LED Dimmable Drivers. Condition is "New".

**Made in Italy not Cheap Chinese drivers!** These retail between £35 - £40 each

• THESE ARE A BARGAIN! AND CAN BE BOUGHT EVEN CHEAPER IN BULK IN MY OTHER LISTINGS

MULTICURRENT-MULTIVOLTAGE DIMMABLE (trailing and leading edge) ELECTRONIC DRIVER FOR POWER LED AND LED MODULES.

DC JOLLY MD is a multicurrent and multivoltage LED power supplier selectable by DIP SWITCH. It incorporates a dimmer controllable by normal open push button. Moreover can be dimmed by phase cutting dimmer.

INPUT

• Nominal: 230/240 Vac 50 Hz: Double Terminal block for up to 0,5 2,5 mm

• Second terminal block to loop other 16 units (Imax=3A):

• Clamping screws for cables with diameter 81.5.7 mm, Max input current 0,17 A

• Power factor X 0,97

• Harmonic content of mains current according to EN 61000-3-2

OUTPUT

• SELV insulation on output Terminal block for up to 1x0,5 25 mm²

• Strain relief for cables with diameter 8 1,5...7 mm

• Selection of current and voltage output through DIP SWITCH (See table), Max output power and current precision 230/240 Vac

• 32 W@ 700 mA 5% (2 46 V)

• 24 W @ 500 mA 5% (2 47 V).

• 17 W @ 350 mA = 6% (2 47 V); 32 W @ 900 mA 5% (2.. 35 V)

• 32 W @ 750 mA 5% (2 47 V)

• 25 W@ 550 mA± 5% (2.47 V):

• 22 W @ 28 V 5% (900 mA max);

• 20 W 24,5 V 5% (900 mA max) 10 W @ 12 V 6% (900 mA max)

• Max output voltage: 53 VDC, Possibility of switch on the LED on secondary side.

• Efficiency@fulll load: 0.89% DIM 50% -0,87% • Consumption without load 1,2 W.

DIMMING

• PWM controlled by phase cutting dimmer (trading and leading edge)

• or by normal open push button, Terminal block on primary side for push button: connection between phase and terminal block (impedance 170 Kohm)
• Dimming level memory at mains restore (push button mode), Header for other power supplier synchronization in push button mode (1 master+9 slaves max)

PROTECTIONS

• Against input overvoltages from mains (according to EN 61547)
• Against short circuit and open circuit
• Thermal and overload protection (C5a EN 61347-1)

EMI

• According to EN 55015.

AMBIENT

• Ambient temperature -25.....50°C
• Ambient temperature: -25.....45°C for 700mA-750 mA
• tc 75°C
• tc life 50000H 70°C

SAFETY

• Hi pot test: 3,75 kV. 100% for 2 seconds STANDARDS

• EN 61347-1, EN 61347-2-13: EN 61547

• EN 55015, EN 61000-3-2 DIN VDE 0710 tell 14