If you are unsure if this belt will fit your vacuum message us. 

NOTE: These belts will be likely shorter than the belt you took off your vacuum. Belts lose elasticity from being stretched to almost twice their original length. After a few months the belt will be an inch or so longer. 
Be sure your brush roll will spin freely before installing your new belt. Also make sure the belt is not pinched or restricted before you turn the vacuum on by turning the brush roll by hand before you plug the vacuum in. If your belt is restricted from spinning freely the motor shaft will melt through your new belt and you may smell burning rubber. This does not mean you got a bad belt, it means the belt was installed improperly or your brush roll is not spinning freely as it should. A stretched belt may slip on the motor shaft but a new tight belt will not. 

Please ask if you have any questions.