【 Compatible with 】：
Ford Edge, Explorer, F150, MKX, MKT, MKZ, Mustang, Flex, Fusion Hybrid, Milan, Sable, Taurus, Taurus X 3.5L&3.7L 4V Engines.
 
【 Material 】：
High standard structural steel with good mechanical properties, solid enough and resists rust with black oxide finish.
 
【 Function】：
Use this tool to accurately position and align hold for Ford 3.5L & 3.7L camshaft at TDC to perform service. Helps ensure Camshaft alignment during removal and installation of the timing chain.
 
【 Package Included 】：
2 * Camshaft Holding Tools, 1 * Tension Tool
 

Compatiable with : 3.5L Edge 2007-2014; 4.0L Edge 2011-2014;

Compatiable with : 3.5L Explorer, F150 2011-2014; 3.7L F150, MKX 2011-2014;

Compatiable with : 4.0L F150, MKX, Mustang 2011-2012; 3.5L Flex 2012-2014;

Compatiable with : 3.5L Fusion Hybrid 2010-2012; 3.5L Milan 2007-2011;

Compatiable with : 3.5L MKS, MKT 2010-2014; 3.7L MKS 200-2014;

Compatiable with : 3.7L MKT 2010-2014; 3.5L MKX, MKZ 2007-2012;

Compatiable with : 3.7L MKZ 2013-2014; 3.7L Mustang 2011-2014;

Compatiable with : 3.5L Sable 2008-2012; 3.5L Taurus, Taurus X 2008-2014

303-1530

 

  • 1. Instert the 303-1530 through the hole in the top of the mega cap
  • 2. Compress the secondary timing chain tensioner and install the 303-1530 in the rear of the secondary timing chain tensioner guide. Position the Chain Tensioner Hold Down Tool against the mega cap to retain the tensioner in the compressed position.
  • 3. Perform service to secondary timing chain as required to vehicle service manual

 

303-1248

 

  • 1. Rotate the engine to No.1 TDC
  • 2. Install the 303-1248 on to the flat the camshaft.
  • 3. Perform camshaft service as required.
  • 4. Refer to the vehicle service manual for the correct camshaft to cranshaft timing procedure.
  • Note: The camshaft holding tool will hold the camshaft in the Dead Center (TDC) position.

 

Holder Tool-3

 

  • Material：High standard structural steel with good mechanical properties, solid enough and resists rust with black oxide finish.
  •  
  • Package Included :
  •  
  • 2 * Camshaft Holding Tools
  • 1 * Tension Tool

 

 
holder tool-1

 

  • Use the camshaft holding tool to hold the camshafts in the Top Dead Center (TDC) position, Insert the chain tensioner hold down tool through the hole in the top of the mega gap and position it against the mega gap to retain the tensioner in the compressed position.Helps ensure vehicle maintenance accuracy and protection.

 

 

  • Use this tool to accurately position and align hold for Ford 3.5L & 3.7L camshaft at TDC to perform service.
PushAuction