Toledo Pipe Reverse Jaws use RIDGID® 300 or RIDGID® 535 cut 2-1/2 - 6" Pipe Instead of RIDGID® 258 Pipe Cutter

Easily cut 2 1/2" - 6" Pipe using your existing RIDGID 300 or RIDGID 535 Pipe threading machine. If you are occasionally cutting large diameter pipe this is your best solution. Enhancing the capability of your pipe machine and not tying up thousands of dollars in a cutter that gets occasionally used.

• Install or remove in less than one minute without any changes to the pipemachine.
• The internal jaws fit inside the end of the pipe. Expand them outward until they evenly touch the inside wall of the pipe at three points of contact.
• Roll cut 6" thinwall in less than one minute
• 6" schedule 40 steel pipe in less than 4 minutes!
• 4" thinwall in less than 30 seconds!
• Compatible with steel, stainless steel, aluminum, plastic and unlined cast iron pipe.
• The machine turns the pipe, making roll cutting easy.
• No scars are placed on the outside of the pipe.
• Provides accurate, square cuts.
• No abrasive saw blades to replace.
• Pipe machines usually turn 30-60 revolutions per minute - sufficient to quickly roll cut pipe.
• The jaws reach 1/2" inside the pipe and will not interfere with roll grooves. (Proper grooves begin 5/8" from the end of the pipe)
• Perfect for use in pipe welding - hold and rotate large diameter pipe as needed.
• Comes complete with a convenient case that clips onto the leg of a stand below the power drive.
• Standard set of REVERSE Jaws will grip 2-1/2" to 6" pipe.

The product is designed and manufactured by Toledo Pipe Tools®.

RIDGID® Marks are trademarks of RIDGID, Inc and are used for product identification purposes only.

Toledo Pipe Tools® does Warranty this item against manufacturer Defects for One Year.