*Normally Closed – Opens when power is applied
*Gravity Feed Capable – No Minimum Pressure
| Function | Normally Closed |
| Connection | 3/4” Inch FNPT |
| Temperature Range | 15 – 250F |
| Pressure Range | 0 - 90 PSI (No Min.Pressure) |
| Power Requirements | 20 Watts |
| *Suitable Media |
Water – Air - Gas - *Etc |
| Body Material | Engineered Nylon Plastic (PA66) |
| Components | Stainless Steel |
| Seal Material | EPDM |
| Operation Type | Semi-Direct Lift Valve |
| Coil Connection | DIN 43650A |
| Orifice Size | 20 mm |
| Cv Value | Cv 7.6 (approx. 58GPM@60PSI) |
| *Duty Cycle | 100% but not indefinitely |
| Weight | 1 lbs 1 oz |
| Height | 3.90" |
| Length | 2.38" port to port |
| Width | 1.95" |
Connection – DIN Connector, DIN 43650A, with H Class - IP 65 - NEMA 4 enclosure rating.
The valve is fast acting. Less than one second.
Zero Differential Pressure is required.
Mounting position is
preferably coil up but can be mounted in any position.
*Consult a chemical
compatibility expert for correct seal and valve body material choice.
*Duty Cycle – Like
most solenoid valves the coil will become hot to the touch when left on
continuously. The temperature will stabilize without failure. Leaving the valve
powered on for long periods of time will reduce the life of the coil. Whenever
possible the valve should be installed in a well ventilated are to increase the
life of the coil. The valve is not intended to be left energized as a fail-safe
for power outages. In this case please contact us for other options.
A pre-filter is
always recommended to keep the diaphragm free from debris and the valve
functioning properly.
