License Plate Light Load Resistors Resistance Indicator 25 Watt 10 Ohm

The description of this item has been automatically translated. If you have any questions, please feel free to contact us.


You offer 2 resistance here
Including 4 power thieves for connecting to the turn signal cables, universally usable for all vehicle types.

25 watts 10 ohms
Voltage 11.5-14.8 volts
L*b*h approx. 2.5cm*1.5cm*1.5cm
Cable length approx. 10cm



When using LED indicators, the flashing frequency can occur.
In order to restore the normal flashing frequency, the installation of these resistors is sufficient.
It is sufficient if you install a load resistance per side.
The load resistor we switched parallel to the LED lamp (as a new consumer not in series).
For Allen work on the car, please disconnect the battery!
Because of the heat development, I would like to point out that the resistors should definitely be attached to metal.
Simple plug & play exchange in which you connect the included "electricity thieves" to the turn signal cable

Legal note

You offer 2 resistance here Including 4 power thieves for connecting to the turn signal cables, universally usable for all vehicle types. Voltage 11.5-14.8 volts L*b*h approx. 2.5cm*1.5cm*1.5cm Cable length approx. 10cm When using LED indicators, the flashing frequency can occur. In order to restore the normal flashing frequency, the installation of these resistors is sufficient. It is sufficient if you install a load resistance per side. The load resistor we switched parallel to the LED lamp (as a new consumer not in series). For Allen work on the car, please disconnect the battery! Because of the heat development, I would like to point out that the resistors should definitely be attached to metal. Simple plug & play exchange in which you connect the included "electricity thieves" to the
Herstellernummer nicht zutreffend
Hersteller Markenlos
EAN Nicht zutreffend