Custom "MAGNUM" black matte vinyl lettering that fits on the air filter cover of the STIHL chainsaws. It's the standard size and fits most other STIHL products too.

I make these and measured for my own saw. approx. size is 1" x 3. Pretty much a direct same fit as a original STIHL sticker. These are cut from solid black HIGH PERFORMANCE 8 YEAR HEXIS exterior sign vinyl on my sign plotter.

These are not printed on a clear sheet. 

Easy to apply, just make sure the cover is ABSOLUTELY CLEAN and ready for the vinyl. Tape the bottom down and flip it over to peel the wax coated backing. I use a credit card or bondo squeegee to apply, works good ..... THERE ARE YOU TUBE VIDEOS!

Made these with the little alignment tabs that you peel off afterwards. 

Again I personally make these so if you have any questions I will answer. 

I do a lot of vinyl work and found that what buys you a few seconds in placement is lightly soapy water, just a bit of soap. The solution dissipates and the decal sticks. You can move it around a bit for those few seconds. Then squeegee it down. Wait a minute or so before peeling the front transfer tape off. Make sure though that the surface is absolutely clean before all this. 

Do I need to mention that the air filter cover nor anything else other than just the black "MAGNUM" vinyl lettering.

THANKS, JAMES

Oh and if you're international I'll need to charge $1.99 for mailing in a stamped letter envelope.