# Product Type: Model‑specific water‑slide decals
# Quantity: 1PC * Water‑slide decals
# Suitable for ages 14 and above


# Required Supplies: decal setter, toothpick, cotton swabs and paper towels.

# Step‑by‑Step Application Guide
1. Prep Model Surface: Clean dust and grease off the model. Apply one layer of gloss clear coat and let it dry completely, which helps decals stick firmly and avoid peeling later.
2. Soak Decals: Submerge decal together with backing paper into clean water for 5‑10 seconds until the pattern can slide freely.
3. Rest Decal: Take out decal and leave it on dry surface for 30‑60 seconds to activate adhesive.
4. Shift Decal: Slide the decal from backing paper onto your model part. Do not remove the backing paper yet.
5. Adjust Position: Reposition decal gently with toothpick or cotton swab, pull the backing paper out after proper alignment.
6. Remove Water and Bubbles: Place paper towel over decal, press and roll gently to squeeze out trapped water and bubbles, do not rub back‑and‑forth.
7. Apply Decal Setter: Put a thin coat of decal setter on top of decal, leave it 30‑60 minutes to fully cure.
8. Final Seal: After full drying, spray gloss clear coat over decals to protect the markings from peeling and fading.

Important Tips
‑ Operate gently, decals are ultra‑thin and easy to tear.
‑ Apply decal setter in small amounts several times for curved surfaces.
‑ Let decals dry overnight before weathering or matte coat.
‑ Do not work in dusty or humid surroundings.