LMR-100A-UF
LMR-100A-UF cable, manufactured by Times Microwave Systems, is designed for low loss general-purpose applications. The LMR-100A-UF was designed as a much more flexible alternative to the LMR-100A cable. This is achieved by employing a stranded centre conductor and a TPE rubber outer jacket.
The LMR range is recognised globally as the industry standard ultra low loss, flexible, low cost, lightweight, DC – 6GHz coaxial cable solution for many RF applications. This is also backed up by the best warranty and technical support in the business.
Important Alert: There are many "fake" or "alternative" attempted copies of the Times Microwave Systems LMR® High Performance Coaxial Cable and Connector range - buy only 100% genuine Times Microwave Systems Products - available only here on eBay from an official UK Authorised Distributor.
How are the LMR-100A-UF low loss figures achieved?
This is achieved due to the cable construction specifications. The centre conductor uses a high conductivity, Stranded bare copper centre conductor material. The dielectric is nitrogen injected, foamed, closed cell, Polyethylene which helps achieve 66% Velocity of Propagation. The Dielectric has a Aluminium foil outer conductor, which is chemically bonded on to it. Due to the cable construction, the attenuation is significantly lower as compared to single shielded coaxial cables.
Outer Jacket
The LMR-100A-UF comes with a black TPE Jacket.
Frequency Operating Band
LMR-100A-UF is designed to operate excellent from DC – 6GHz. For any frequency band at VHF and above LMR is the obvious choice.
Applications
LMR-100A-UF Flexible Low Loss Communications Coaxial Cable is ideal for:
- Drop-in Replacement for RG-316/RG-174 (uses standard connectors)
- Jumper Assemblies in Wireless Communications Systems
- Short Antenna Feeder runs
- WLL
- GPS
- LMR
- WLAN
- WISP
- WiMAX
- SCADA
- 3G or 4G repeaters
- Radio antennas or receivers
- VSAT Applications
- TVRO
Attenuation
| Attenuation — dB per 100m | |
| Frequency | Attenuation |
| 30 MHz | 12.9 dB |
| 50 MHz | 16.7 dB |
| 150 MHz | 29.4 dB |
| 220 MHz | 35.8 dB |
| 450 MHz | 51.9 dB |
| 900 MHz | 74.9 dB |
| 1500 MHz | 98.7 dB |
| 1800 MHz | 109.0 dB |
| 2000 MHz | 115.5 dB |
| 2500 MHz | 130.6 dB |
| 5800 MHz | 210.3 dB |
Construction
| Construction | ||
| Component | Material | Diameter |
| Inner Conductor | Stranded BC | 0.46 mm |
| Dielectric | Foam PE | 1.52 mm |
| Outer Conductor | Aluminium tape | 1.65 mm |
| Overall Braid | Tinned copper | 2.11 mm |
| Jacket | Black TPE | 2.79 mm |
Mechanical & Environmental
| Mechanical Specifications | |
| Property | Value |
| Bend Radius, installation | 6.4 mm |
| Bend Radius, repeated | 25.4 mm |
| Bending Moment | 0.014 Nm |
| Weight | 0.014 kg/m |
| Tensile Strength | 6.8 kg |
| Flat Plate Crush | 0.18 kg/mm |
| Temperature range | -40⁰C to +85⁰C |
LMR® is a registered trademark of Times Microwave Systems