NANKADF series laboratory switching power supply is a full-featured, simple and beautiful design of easy to operate power supply. The small body is made of high-quality components, the power supply itself has short-circuit protection, over-voltage protection, over-current protection, over-temperature protection and other perfect protection mechanisms, ideal for the majority of electronic enthusiasts and beginners to use.
Voltage, current, power three-line LED high-definition display
The display has a protective film (you need to check it yourself because of the tight fit with the screen)
Unlike the analog regulation of ordinary DC power supply, this power supply is regulated by encoder. It will make it easier and faster for you to set the power supply parameters.
The size of the product is only: 5.9in*3.54in*7.48in
Bare weight only: 2.64lbs
The small size and mass of this power supply will not take up too much space on your workbench.
The power supply is configured with an output on/off switch. The setting of this button turns the output of the power supply on or off. And in case of short-circuit alarm, pressing can release the alarm and enter the off output state.
This model supports an independent USB fast charging port with a built-in fast charging protocol chip and a maximum output power of up to 18W to provide fast charging for cell phones, PADs, charging pads and other devices with fast charging protocol. The output power is automatically adjusted according to the fast charging protocol supported by the device being charged, and will be output at standard 5V when used by devices that do not have fast charging capabilities.
This power supply can accurately set the voltage and current you need, and it can automatically calculate the output power based on the output voltage and current, while displaying the voltage, current, and calculated power on the screen.
Different from the power supply with ordinary single voltage input type. This power supply has 110V/220V dual voltage input, which allows you to use in different country locations.
The bench power supply requires no manual configuration. It will automatically select the appropriate input voltage setting.
You will get.
| Input power | AC 230V/115V±10%; 50Hz/60Hz |
| Operating temperature | 0℃～40℃;Relative humidity:<80%RH |
| Storage temperature | -10℃～70℃;Relative humidity:<70%RH |
| Auxiliary functions | USB fast charging, OUT output on/off, |
| Protection mode | OVP over-voltage protection, OCP over-current protection, over-temperature protection, short-circuit alarm to stop the output |
| Voltage stabilization state CV | Voltage stability: 0.5%±3mV、 Load stability: 0.5%±3mV 、Ripple voltage: ≤0.5% |
| Current stabilization CC | Current stability: 0.5%±3mA、 Load stability: 0.5%±3mA 、Ripple current: ≤0.5%、 Vp-p Recovery time: ≤500μS 、Temperature coefficient: ≤100ppm/°C |