Features
·
Better reproduction detail with two
viscosities (Putty & Light Body)
·
Exhibits pseudo-plastic properties for precision which
is not found in alginates
·
Superior tear strength than any
other VPS material
·
Better dimensional stability – multiple
models can be poured up to two weeks
·
Good hydrophilicity
·
Compatible with gypsum products
·
Superior wetting characteristics ensuring gypsum
working cast is hard with smooth surface
·
Can be subjected to cold sterilization without
compromising the details and dimensional stability of the impression
Description
Vinyl polysiloxane impression material
FLEXCEED, with its lowest contact angle, displaces moisture and lows into
subgingival areas rather than lowing away to mucosal surfaces, thus producing accurate impression detail.
It has High Initial Hydrophilicity & Viscosity .
It gets pushed into the sub-gingival area easily to register
the details. The flow of FLEXCEED Putty-Wash is better than most of the brands.
FLEXCEED LIGHT BODY is more hydrophilic:
The initial contact angle of a water
droplet on an impression material helps measures the ability of a material to
wet surfaces
FLEXCEED exhibits the
highest tear strength to give an accurate impression detail everytime.
The subgingival and interproximal
regions of the impression are often very thin and can tear during the removal
of the impression. FLEXCEED has been tested to have the highest strength to
resist tearing in comparison to other vps impression materials.
The subgingival and
interproximal regions of the impression are often very thin and can tear during
the removal of the impression. FLEXCEED has been tested to have the highest
strength to resist tearing in comparison to other vps impression materials.
INDICATIONS:
·
For impressions in cases of veneers, inlay, onlay, crown or bridge
Key Specifications
PHYSICAL PROPERTIES:
|
|
LIGHT
BODY |
PUTTY |
|
Mixing
Time |
|
20 sec |
|
Total
Working Time |
2 min |
1 min |
|
Minimum
time in Mouth |
3 min |
3 min |
|
Elastic
recovery |
More
than equals 98% |
More
than equals 98% |
|
Strain
in Compression |
2.5-3.5
% |
1-2% |
|
Linear
dimensional change |
Less
than or equals to 0.20% |
Less
than or equals to 0.20% |
|
Detail
Reproduction |
20 μm |
75 μm |
|
Compatibility
with Gypsum |
20 μm |
75 μm |
Packaging
GC Flexceed Putty :
·
1 x (500g) 278ml Base
·
1 x (500g) 278ml Catalyst
GC Flexceed Putty + Light Body Kit:
·
1 x (500g) 278ml Base
·
1 x (500g) 278ml Catalyst
·
2 x 50ml Light Body Catridge
·
8 Mixing tips
·
8 Intra oral tips
GC Flexceed Light Body :
·
2 x 78gm (50mL) Cartridge
GC Flexceed Putty + Light Body Kit
(Mini Kit)
·
1 x 300gm (167ml) Base
·
1 x 300gm (167ml) Catalyst
·
1 x 78gm (50mL) Cartridge
·
1 x Measuring Scoop Base
·
1 x Measuring Scoop Catalyst
·
4 x Mixing Tips
·
4 x Intraoral Tips
Direction to Use
I. Single step putty wash impression
STEP 1:
Take equal quantities of FLEXCEED
base & catalyst using the prescribed scoop
STEP 2: