The RC XP Deus 2 case is made using 3D printing technology. The lightweight and durable construction protects the panel from rain and mechanical damage.
The display is protected with two layers of protective film, and the outer film is scratch-resistant.

Assembling the case is very intuitive. Before inserting the panel into the case, unscrew the 10 screws connecting the housing parts. Insert the panel into the lower part of the case, then place the upper element on top, securing the entire assembly with screws. A wrench is included. Tighten the screws gently until you feel a slight resistance.

The housing allows for the installation of:

• a dedicated latch attached with screws directly to the bottom of the housing
• a reflector module that protects against sun reflection from the display

Both items are available in the store in the "detectoristics" tab.

The RC XP DEUS 2 housing is not waterproof and cannot be submerged in water. (It has an open design and water may flood the panel)

PLEASE NOTE THE SUNSHADE WONT FIT ANYTHING OTHER THAN THE HADES DEUS 2 HOUSING!

RC XP DEUS 2 HOUSING IS NOT WATERPROOF AND CANNOT BE IMMERSED IN WATER. (IT HAS AN OPEN DESIGN AND WATER MAY FLOOD THE PANEL)