■ THEdoûr Bespoke
TAMdoûr  ·  2000 × 800 mm  ·  EASY CUT

Tambour Campervan Shower Door

Pre-assembled, cut to fit, with a flexible track for a straight, 90° or curved close

2000 mm
TALL, CUT TO FIT
800 mm
WIDE, REMOVE SLATS
Flex
TRACK INCLUDED
ABS
NOT PVC

A space-saving sliding shower door

The TAMdoûr tambour door slides smoothly along a top and bottom track and tucks away inside your shower room, so there is no door swinging into your living space. It is ideal for campervans, motorhomes, RVs, boats and tiny homes.

It arrives pre-assembled at 2000 mm tall by 800 mm wide. You trim the height to suit your space and remove slats to reduce the width. Lightweight and waterproof, it is made for wet areas.

Choose your colour

ColoursMatt Satin Black  ·  Matt Satin White  ·  Classic Silver
How to orderChoose your colour from the drop-down menu at the top of this listing
HandleColour-matched to your door

Colours on screen may vary slightly from the real finish.

What's in the box
■1 × pre-assembled tambour door (2000 × 800 mm)
■2 × 1600 mm flexible track (top and bottom)
■2 × U-channels to support the track on straight runs
■Colour-matched L-shaped trim (door stop, or to hide the track corner)
■Magnetic tape for a tidy magnetic close
■Colour-matched handles

Adhesive and silicone spray are not included.

EASY CUT

Cut it to your size

Fit the tracks first, then cut the door. Make sure the top and bottom surfaces are level and parallel.

Door heightMeasure the space between the two mounting surfaces and take off 12 mm (each track sits 6 mm off its surface). E.g. 1800 mm space = 1788 mm door.
Using the U-channelsTake 10 mm off at the top and 10 mm at the bottom instead (track + channel = 9 mm).
Reduce the widthEach slat is 25 mm. Carefully cut the tape at a join and slide out as many slats as you need.
Cut the heightMark the line across the slats, cut them together with a fine-tooth saw and sand the edges.
Handle slatRemove the black end plugs and the 3 screws, slide off the ABS cover. Cut the ABS cover 5 mm shorter than the slats at each end, and the aluminium slat 15–17 mm shorter at each end. Refit the cover, handle, screws and plugs.
ToolsFine-tooth saw, tape measure, pencil, screwdriver and sandpaper. Wear gloves and eye protection.
TRACK

Straight, 90° turn or curved close

■The flexible track lets the door run straight, round a gradual 90° bend, or close on a curve.
■Warm the track with a hairdryer while shaping it, especially in cold weather. Bends must be gradual, as a sharp bend can pull the track apart.
■Use the U-channels on the straight runs only, not on the curve.
■Slide-back space needed: the door width minus 40 mm. E.g. a 600 mm door slides 560 mm inside, leaving the handle at the opening.
FITTING

Fitting in 5 steps

01Bond the bottom track in your chosen shape with adhesive (not screws) and leave it to dry overnight. Fit a water barrier at least 15 mm high in front of it.
02Insert the door, then mark and fit the top track parallel to the bottom. An adjustable batten makes this easy. Leave a 0–0.5 mm gap above the door.
03Tilt the door into the tracks (or fit it to the bottom track, then add the top track and batten).
04Fit the L-shaped trim on the inside as the door stop. Stick the magnetic tape to it so it lines up with the magnet in the handle slat.
05Stick the rear handle on at the height you want. Add a little silicone spray to the tracks for a smooth slide.

Every van is different, so some DIY experience helps. Plan the track layout carefully. Questions? Message us before you start.

Why TAMdoûr?

Premium ABS slatsHold their shape in summer heat and winter cold, where PVC can stick, gap or rattle.
Fully backed aluminium handle slatStrong and stable for doors up to 1000 mm wide.
¾ wrap-around slat jointsNo rubber connectors to perish or leak.
Low-friction trackA ridge inside the ABS track for a smooth, quiet slide.

Care

■Clean the bottom track regularly.
■Wipe the door with a soft cloth and mild detergent.
■Over the years, lower the top batten slightly if the bottom track settles.

Key sizes

Door2000 × 800 mm, pre-assembled
Slats25 mm wide × 12 mm deep, ABS
Handle slat40 mm, aluminium backed, with magnet
Track2 × 1600 mm flexible
ColoursMatt Satin Black, Matt Satin White, Classic Silver
■ THEdoûr Bespoke
Your Space, Your Style, Our Priority.
A family business in Pembrokeshire, Wales. Questions on sizes, colours or fitting? Message us through eBay.