TURTLE AIR-3 ROOF BAR IS MOUNTED IN THE FACTORY MOUNTING POINTS IN THE VEHICLE ROOF AND ONLY FITS MODELS WITHOUT RAILING.


Turtle Air-3 is a very light and flat aluminum base frame. Aerodynamic shape.
Quiet driving and high quality are the main advantages of this model. The great practicality of assembly allows it
Simultaneous installation of many accessories with easy-to-use clamp or T-bolts.

Features Turtle Air-3


  • Modern flat aluminum design
  • Non-slip rubber seals
  • Aerodynamic shape
  • Very quiet while driving
  • Special anti-theft protection (locking in both heads) with two keys
  • Available in silver and black
  • Easy assembly without additional tools
  • Install accessories with a convenient clamp or T-bolt.
  • Adjustable length (up to 10 cm)
  • Bar width: 7 cm
  • 2 year guarantee
  • Maximum load capacity: 75 kg / 165 lbs

During installation it is important to follow the recommendations below:


1. Lift the plastic caps covering the mounting points at the appropriate locations along the roof, then insert and remove the appropriate screws at the mounting points to clean the holes.
2. Place the clip on top of the mounting bracket.
3. Place the center plastic spacer over the exposed mounting hole with the arrow pointing outward.
4. Tighten the mounting bracket.
5. Tighten the allen screw on the mounting head.
6. Connect the brackets to the aluminum beams. Slide the beam all the way into the mount until you hear a "click". Only the fully inserted beam is locked into the mount.
7.Attach the plastic part with the gasket to the mounting head.
8.Fit the kit into the metal mounting bracket on the roof.
9.Tighten the mounting screws to secure the kit in the mounting brackets.
10.Then, tighten the adjustment screws to lock the beams in the heads. After tightening, make sure the beams do not move between the mounts.